Miracle One
Electromechanical Linear Gate Operator with Master/Slave Control Panel
Linear mechanical,
24 volt DC gate operator. It uses a precise limit switch system that reduces
stress and creates a consistently smooth operation The Miracle-one™
is one of the first linear mechanical, 24 volt DC gate operators that offers
all the features the consumer demands. One of these features is variable
speed, which is electronically controlled by a micro controller and precise
limit switch system. The gate operator starts the cycle slowly, increases
in speed, then comes to a stop slowly with the use of internal limit switches.
This reduces stress and creates consistently smooth operation. Battery backup
is included to provide fully functional operation for 100-200 cycles in
case of power failure. Also included are a 2 way reversing sensor and a
vandalism/burglar alarm indicator. The Miracle One&tm; is ultra quiet, has
a weatherproof housing, and features an Manual Disconnect Key. The state
of the art features offered in the Miracle-One™ make it one of the most
advanced operators in the world and will create new standards in the gate
operator industry.
ELECTRICAL SPECIFICATIONS
Alarm
Output Can be interfaced with any home alarm system. Alarm will
sound if the gate is forced open. Optional siren can be installed
Alternate
Outputs Sensor Alarm, alarm system, and magnetic locks
Burglar
Alarm With Omni Option board, interfaces with existing home alarm
or alarm output
Digital
Motor Protection Entrapment sensor shuts off the motor after
it reaches the stall amp for 3 seconds, reverses direction for several
inches and stops
Electronic
Inputs Any type of radio receiver, full-control system "push-open/stop/close",
hold open loop, photocell, telephone entry, and key switch
Master-Slave
Option Dictates synchronized movement between two gate operators
Modular
Board Uses LEDs to indicate all input and output functions of
the gate operator
Optional
Solar Input The optional Solar package allows the Mircle-One;
to operate as an independent unit with the use of DC Adapter and Solar
Panel
Reversing
Sensor If the gate hits a vehicle while opening, it will reverse
a few inches and stop. If it hits a vehicle while closing, it will reopen
Running
System Uses a microcontroller with built-in "watchdog" system
Spike Suppressors
Electronic system is protected by spike suppressors
Timer
Can be set from 3 to 60 seconds, or "push-open/stop/close" operation
MECHANICAL SPECIFICATIONS
Approval
UL and ETL listed to the latest UL325 and UL991 specifications
Dimensions
L 39.5in x W 3.5in x H 4in
Emergency
Release The gate is easily disconnected by turning the release
handle. the best option is our DC-1000SL
Finish
Aluminum
Gate Length
15 feet wide max
Installation
Can be installed two ways: "Open inside/Close Outside" or "Open Outside/Close
Inside"
