The
Model Fire-2000 uses a micro switch to open the gate. It
is made of 14-gauge steel, powder coated bright red. The front door
has a hole for a standard padlock, which can be removed by the Fire
Department. A blank label on the inside of the door is provided for
written instructions and there is ample room for stored "gate
release" keys. Dimensions: 6" (H) x 5 1/2" (W) x 3"
(D)
The
Model Fire-2010 has an Ace cylinder lock that also has an
additional hole to accept a Knox KS-2 key lock. This can be purchased
from your Fire Department. It is made of 14-gauge steel, powder coated
bright red, and is labeled with a Fire Dept. label on the front cover.
Dimensions: 6" (H) x 5 1/2" (W) x 3" (D)
The
Model Fire-2070 is easily used in a power failure as an emergency
release by pulling on the handle. It has a bright red powder coat
finish with a Fire Dept. label on both sides. Dimensions: 6"
(H) x 4 1/2" (W) x 4" (D)
Key-2020:
The Model-2020 has an Ace cylinder lock, as well as a Mortise cylinder
lock with a limit switch. The Ace lock gives access to the box itself,
while the Mortise lock (which can be keyed to the house locks) gives
momentary contact to open and close the gate. The rugged black steel
box with stainless steel faceplate has punch-outs for surface or post
mounting. Two keys are supplied for each lock. Dimensions: 5 1/2"
(H) x 41/2" (W) x 4" (D)
Key-2030:
The Model 2030 has two Ace cylinder locks that are keyed separately.
The top lock gives access to the box itself, while the bottom lock
gives momentary contact to open or close the gate (the key is removable
in the "closed" position only). Construction and mounting
features are the same as the Model-2030 and two keys are also supplied
for each lock. Dimensions: 5 1/2" (H) x 41/2" (W) x 4"
(D)
Key-2040:
The Model-2040 has two Ace cylinder locks that are keyed separately.
The top lock gives access to the box itself, while the bottom lock
gives momentary contact to open or close the gate (the key is removable
in either position). The construction and mounting features are the
same as the previous models and two keys are provided for each lock.
Dimensions: 5 1/2" (H) x 41/2" (W) x 4" (D)
Pedestal-Pad
Mount - The Pad Mount Pedestal has a 90° sweep to allow
easy access. The Pas Mount dimensions are 2" x 2" x 42"
long x 1/8" thick. The accessory plate is 4" x 4" x
1/8" steel with 4 slotted 1/4" holes foe accessory mounting,
as wall as a 2" square opening for wiring. All of the pedestals
parts are black powder coated.
The
In-Ground Pedestal has the same features as the "Pad
Mount" pedestal, with the exception of the primary dimensions
which are 2" x 2" x 62" x 1/8" thick.