| Diamond
Control Board - The unique Diamond board uses state
of the art technology combined with easy of use to provide
many exceptional new features that cannot be found on any
other board.
2 Wire Maser/Slave - The Diamond board uses
a unique Master/Slave system that requires only two wires.
Motor Brake - If the on position is selected,
the gate will stop instantly when it reaches the limit switches.
This is essential on uphill/downhill applications and on all
Fail Safe operations.
One Pass - This tailgating feature works
with the reverse loop to allow only one car to pass. After
the car passes the gate closes instantly, if a second car
approaches the gate stops, and resumes closing once the car
has left.
Stop-Reverse - This radio feature allows
the transmitter to work as a three-button station and is useful
for partial opening. The first command opens the gate, the
second stops the gate, and the third command will close the
gate.
Timer - The adjustable timer can be set from
1 to 60 seconds, with a maximum run time of 60 seconds.
Overload - If the motor reaches the stall
amp for 3 seconds, it will automatically shut down.
Receiver - The receiver terminal is mounted
on the control box for easy installation and is pre-wired
for a 3-wire or 4-wire receiver.
Stainless Steel Access Door - Offers full
access to the control board through the locking stainless
steel door. |
|
ERD - If the gate hits an obstruction while
closing, it will re-open. If it hits an obstruction while
opening, it will stop, reverse 6 inches and stop again. The
sensitivity is adjustable separately for the open and close
cycles.
Global Inputs - The Diamond board's Global
Inputs include key switch, keypad, exit loop, phantom loop,
reverse loop, edge sensor, open, stop, and close.
Outputs - Outputs include on board 24 VDC
for MAG Lock, alarm, and 24 VAC auxiliary power.
Safety Alarm - If the gate hits an object
twice while closing or opening, the system will shut down
for 5 minutes. On the Diamond board you have two options for
reset mode. Selecting the off position will require a manual
reset of the board if the previous happens. However, by selecting
the on position, the system will automatically reset itself.
120 VAC Power Outlets - The operator contains
two 120 VAC Power Outlets for the users convenience.
Power on/off Switch - The operator has an
easily accessible power disconnect switch that allows for
easy installation and service.
No Pinch Arm - This safety features prohibits the arm from extending past the operator's body when the arm is in the fully extended position.
Gate Opening - Can operate to either the
left or right side.
Warranty - Five Year residential use. |
